REMKO CLK 30 - Manual (Page 11)

11
Proper Use
These units have been designed and equipped exclu-
sively to be used for heating and ventilation for industrial
and commercial purposes.
The manufacturer is not liable for any damage resulting
from non-adherence to manufacturer specifications, le-
gal requirements or any modifications to the units.
Fan does not start:
1. Check whether fan blade is running smoothly.
2. Check the power cord on the air supply fan for dam-
age.
3. Check the fan’s operating capacitor for damage.
It is located in the unit’s control panel box.
4. Check that the fan control thermostat (TR) is work-
ing properly.
G
An operation/use other than indicated in these in-
structions is prohibited!
In the case of non-compliance, we assume no li-
ability and our guarantee becomes null and void.
Service and Guarantee
For the guarantee to be valid, the customer must com-
pletely fill out the “guarantee certificate” enclosed with
all heating units and send it back to REMKO GmbH &
Co. KG in a timely manner after purchasing of the unit
and putting it into operation.
The units have undergone several tests to ensure
proper functioning at the factory. If there are still mal-
functions that cannot be fixed by the operator using the
troubleshooting instructions, please contact your dealer
or contract partner.
Important information about resetting the burner
à If, during the start phase, the unit is switched off
again due to a malfunction, it may only be restarted
after 5 minutes have elapsed.
à Take any steps necessary to prevent another reset.
Danger of deflagration.
G For safety purposes, repair work on the electrical
components and the burner may only be per-
formed by authorised personnel.
G
After working on the unit, conduct an electrical
safety test.