REMKO RVT 261 DC - Manual (Page 10)

HEATING-
MODE
Heating mode operational sequence
> 6 Min. > 3 Min. > 6 Min.
30 sec. 30 sec.
Nominal temperature
+5 °C
Nominal temperature
+2 °C
Fan operation IT
Fan operation AT
Compressor operation AT
Actual
temperature
Stop heating operation
Heating mode
Start heating mode
Functional diagram
Operation
Stop Reverse flow valve
30 sec. 30 sec.
During the defrosting cycle, the indoor unit vaporiser fan and the
outdoor component liquefier fan are switched off.
After the cycle is concluded, the fans are switched to their previous
settings.
< 7 Min.
Defrost period
15 sec.
60 sec.
Fan operation IT
Fan operation AT
Compressor operation AT Operation
Stop
Reverse flow valve
30 sec. 30 sec.
30 sec.
3 Min.
▲
▼
OR
Hr.
ON TIMER
Hr.
Off TIMER
SET TEMP
Turbo
Hr.
ON TIMER
Hr.
Off TIMER
Turbo
SET TEMP MODE
Hr.
ON TIMER
Hr.
Off TIMER
Turbo
SET TEMP
Hr.
ON TIMER
Hr.
Off TIMER
SET TEMP
Auto
Turbo
In the heating mode, you can heat the room in spring or fall. The desired
room temperature is set with the ▲/▼buttons in 1 °C increments. If
the room temperature is 1 °C below the selected target temperature,
the indoor unit starts to heat the air in the room. The inverter controller
checks the difference between the adjusted target temperature and the
actual room temperature.
In the event of a greater difference, a higher cooling performance is
created.
In the event of a smaller difference, a lower cooling performance is
created.
This serves to maintain the air discharge temperature and the room
temperature.
If the adjusted room temperature is still exceeded by approx. 2 °C,
then the control system turns the heating function off. To protect the
compressor, the regulation only turns the heater on again after a waiting
period of 3 minutes.
In heating mode, the indoor unit fan motor is switched on after a delay,
in order to prevent the discharge of cold air.
The fins on the outdoor component could crack at low external
temperatures.
Regular reversal of the cooling circuit results in a defrosting action. The
display shows "H1" during the defrosting period.
HEATING Mode
Hr.
ON TIMER
Hr.
Off TIMER
SET TEMP
Turbo
FAN
REMKO RVT...DC
10