REMKO MXD 200 v.1 - Manual (Page 8)

Operation
infrared remote control
The infrared remote control sends
the programmed settings over a dis-
tance of up to 6 m from the receiver
of the indoor unit. Data will only be
received correctly if the remote con-
trol is pointed at the receiver and no
objects obstruct the transmission
path.
First insert the batteries supplied on
delivery
(2 x type AAA) into the remote con-
trol. To do so, pull off the flap of the
battery compartment and insert the
batteries according to their polarity
(see markings).
The indoor unit is easily operated using the standard infrared remote control. The indoor unit beeps to acknowl-
edge the correct transmission of data. If it is not possible to program the indoor unit using the remote control,
it can also be manually operated.
Faults are indicated in code
(see chapter Troubleshooting
and Customer service).
! CAUTION
Immediately replace flat batter-
ies with a new set, otherwise
there is a risk of leakage. It is
recommended that the batteries
be removed if the equipment is
shut down for long periods.
NOTE
max. 6 m
Maximum distance
Manual operation
The indoor units can be started
manually.
Press the RESET button on the re-
ceiver unit of the cover to activate
automatic mode. In manual mode,
the following settings apply:
Cooling mode: 24 °C,
Fan speed AUTO
Heating mode: 26 °C,
Fan speed AUTO
Pressing any button on the infra-
red remote control interrupts
manual mode.
Display on the indoor unit
Unit for receiving signals
from the remote control
Operation
indicator
Alarm indicator
Display on the indoor unit
The lit LED indicators show the settings.
LED H red = high fan speed
LED M yellow = medium fan speed
LED L green
= low fan speed
Timer
indicator
Fan
Defrost
REMKO MXD
8