REMKO MXD 200 v.1 - Manual (Page 5)

The equipment is shipped in sturdy
transport packaging. Immediately
check the equipment on delivery
and make note of any damage or
missing parts on the delivery note
and inform the forwarding agent
and your contractual partner.
Warranty claims at a later date will
not be accepted.
Equipment description
Transport and
Packaging
The indoor unit on the split-design
combined room air conditioning
units serves to extract heat from
the indoor room being cooled. The
outdoor unit then expels this heat
to the outside.
If combined heating/cooling units
are operated as heaters, the heat
absorbed by the outdoor unit can
be discharged by the indoor unit
into the room being heated.
The unit is designed for installation
high up on indoor walls. Opera-
tion takes place using an infrared
remote control.
Stop valve
Mains cable
Schematic of refrigerant circuit
Connection
to suction
pipe
Connection to
injection line
Vaporiser Vaporiser fan
Refrigerant pipes are used to con-
nect the indoor unit to the outdoor
unit.
Outdoor
component
System layout
Condenser fan
Outdoor area
Injection line
Suction line
Control cable
Condensation line
Indoor area
Condensation line
Indoor unit
The indoor unit consists of a fin
vaporiser, vaporiser fan, controller
and condensation pan. The indoor
unit can be combined with REM-
KO outdoor units of series MVT
600/900/950/1050 DC with suf-
ficient cooling output. The outdoor
component is controlled via the
controller of the indoor unit.
Condensation pumps
are available as an accessory.
Intended use
Depending on the model, the
equipment and the additional
fittings with which it is equipped
is only intended to be used as an
air-conditioner for the purpose of
cooling or heating the air in an
enclosed room.
Different or additional use shall not
be classed as intended use. The
manufacturer/supplier assumes no
liability for damages arising from an
unintended use of the equipment.
The user bears the sole risk in such
cases.
Using the equipment as intended
also includes working in accord-
ance with the operating manual
and installation instructions and
complying with the maintenance
requirements.
5