REMKO MXD 200 v.1 - Manual (Page 16)

2 Cleaning using a vacuum cleaner
Air filter for indoor unit
Clean the air filter at intervals of
no more than two weeks. Reduce
this interval if the air is especially
dirty.
Cleaning the filter
1. Disconnect the supply voltage
to the equipment.
2. Open and fold down the air
inlet guard on the cover. The
filter is held in place by the flaps
screwed in at the side of the
guard (Fig. 1).
3. Tilt the filter to lift it out (Fig. 1).
4. Clean the filter using a normal
vacuum cleaner (Fig. 2).
To do so, turn the dirty side
upward.
5. Dirt can also be removed by
carefully cleaning with lukewarm
water and mild cleaning agents.
To do so, turn the dirty side
downward (Fig. 3).
6. When using water, allow the
filter dry out properly in air
before replacing it in the unit.
7. Carefully insert the filter. Make
sure it is seated correctly.
8. Close the cover as described
above but in reverse order.
9. Switch the supply voltage back
on.
10. Switch the unit on again.
Cleaning the
condensation pump
The indoor unit includes a built-in
condensation pump, for pump-
ing the condensation to a drain at
a higher level.
The pump is more or less mainte-
nance free. The condensation pipes
should be checked for dirt at regular
intervals. Clean them as required.
If an external pump is also used,
observe the maintenance and care
instructions given in the separate
operating manual.
1 Pull out the filter
3 Cleaning with lukewarm water
REMKO MXD
16