REMKO RVT 263 DC - Manual (Page 28)

5.5 Installation, mounting
outdoor unit
Outdoor unit installation location
n The device may be attached only to a load-
bearing structure or wall. Ensure that the out-
door unit is installed only vertically. The instal-
lation site should be well ventilated.
n To minimise noise, install floor consoles with
vibration dampers and a considerable distance
from acoustically-reflective walls to minimise
noise.
n The minimum clearances specified on the next
page should be maintained when carrying out
the installation. These minimum distances
serve to ensure unrestricted air intake and
exhaust. Additionally, there must be adequate
space available for installation, maintenance
and repair.
n If the outdoor unit is erected in an area of
strong winds, then the device must be pro-
tected against them (Fig. 31). The snow line is
to be observed during installation (Fig. 32).
n The outdoor unit must always be installed on
vibration dampers. Vibration dampers prevent
the transmission of vibrations through the floor
or walls.
n A heated, condensate tra ensures that conden-
sation from the pan can drain off. Ensure that
the condensate is prevented from freezing so
that it can drain off (gravel, drainage). The
Water Ecology Act is to be observed.
n During installation, add about 20 cm to the
expected snow depth to guarantee unimpeded
intake and exhaust of outdoor air year round
(Fig. 32).
n The installation site of the outdoor unit should
be agreed together with the operator primarily
so that operating noise is minimised and not in
terms of “short routes”. Thanks to the split-
design technology there are a great deal of dif-
ferent installation options with almost identical
efficiency available.
1
Fig. 31: Protection from wind
1: Wind
NOTICE!
The site for the outdoor unit must be selected
so that machinery noise that occurs disturbs
neither the residents nor the facility operator.
Observe the TA-noise specifications as well as
the table containing the drawings relating to
sound pressure levels..
20 cm
1
Fig. 32: Protection from snow
1: Snow
REMKO RVT...DC
28