REMKO RVT 263 DC - Manual (Page 16)

3 Design and function
3.1 Characteristics of REMKO
inverter air conditioner with
split design
REMKO inverter technology
The air conditioner's condenser is equipped with a
requirement-dependent speed control system. The
power control on conventional air conditioners pro-
vides only two states, either ON (full output) or
OFF (no output). The air conditioner turns on
below a specified temperature and turns off when
this temperature is reached. This kind of heat regu-
lation is very inefficient. Heat regulation in the
Remko inverter air conditioner is modulated to the
actual need. The electronics system has an inte-
grated frequency-converter which serves to modify
the condenser speed and the speed of the blower
as required. The condenser works at a higher
speed when under full load than under partial load.
The lower speeds ensure a longer operational life-
time for the components, improved coefficient of
performance and lower noise. Lower speeds also
result in lower energy consumption (electricity) and
longer service life. I.e.: inverter air conditioner will
run practically throughout the cooling season. In
all, the highest efficiency possible.
Thanks to innovative inverter technology, this
air conditioner will almost always operate by
adapting its cooling capacity to the actual
requirements of the cooling season, and will in
fact turn itself off when heat is removed. The
same applies in the opposite direction with
heating.
1/3
When it is switched on, the inverter only requires
one-third of the time of conventional systems
Time
Minimal temperature fluctuations
mean energy savings
Conventional
Inverter
Temperature
Fig. 12: Modern inverter technology
REMKO RVT...DC
16