REMKO MXW 202 - Manual (Page 17)

"Heating" mode
In "Heating" mode, you can heat the room in spring
or autumn. The selected room temperature is set
using the "Temp" keys in 1 °C increments. If the
room temperature is 1°C below the selected target
temperature, the indoor unit will start to heat the air
in the room. If the set room temperature is
exceeded by approx. 1°C, the controller will switch
off heating mode. To protect the compressor, the
controller will wait 3 minutes before switching on
heating mode again. The fan does not start to
operate until the temperature on the heat
exchanger is 32 °C.
Fig. 15: "Heating" mode
The heating mode has priority!
Turns on the indoor unit to the heating mode,
switch off the other indoor units from which are
in cooling mode, the cooling. During heating
operation can not be cooled.
"FAN" key
Function
1. Automatic
2. Low
3. Medium
4. High
Automatic function:
< approx. 1.5 °C = lower level
> approx. 1.5 °C = middle level
> approx. 3.5 °C = high level
4
3
2
1
FAN
FAN
FAN
FAN
Fig. 16: "Fan" key
17