REMKO MXW 202 - Manual (Page 12)

Alarms are indicated by a code (see chapter
Troubleshooting and customer service).
NOTICE!
Immediately replace flat batteries with a new
set, otherwise there is a risk of leakage. It is
recommended that the batteries are removed if
the equipment is shut down for longer periods.
Help save on energy consumption in stand-by
mode! If the device, system or component is
not in use, we recommend disconnecting the
power supply. Components with a safety func-
tion is excluded from our recommendation!
Display on indoor unit
The display illuminates according to the settings.
2 1 4 3 5
Fig. 5: Display on indoor unit
1: Defrost indicator
2: Operating lamp
3: Timer activated / deactivated
4: Signal receiver
5: Display for setpoint
Keys on the remote control
4
1
7
8
10
11
3
2
13
9
5
6
12
14
15
Fig. 6: Keys on the remote control
1 "ON/OFF" key
Press this key to operate the unit.
2 " " key
Press this key to reduce the temperature to 17 °C.
3 " " key
Press this key to increase the temperature to 30
°C.
4 "MODE" key
Press this key to select the operating mode. The
indoor unit has 5 modes:
1. Automatic mode
In this mode, the unit uses the setpoint to select
cooling or heating mode automatically.
2. Cooling mode
In this mode, the warm air in the room is cooled
down to the preset temperature.
For more, see the next page!
REMKO MXW
12