REMKO RKL 491 DC - Manual (Page 10)

IR
2
1
10
12
14
FAN
TEMP.
ON/OFF
FUZZY
C
TIMER
MODE
17
Fig. 4: Infrared remote control
IR Infrared transmitter
Cooling mode ( )
1. Switch the unit on by means of the "I / 0"
button.
2. Set the temperature selection switch to the
desired nominal temperature.
3. Select the desired fan mode to AUTO, HI,
MED or LO by means of the "MODE" button.
Circulated air mode ( )
1. Switch the unit on by means of the "I / 0"
button.
2. Select FAN mode by means of the "MODE"
button. (Remote control )
The outdoor unit can remain in the room in circu-
lated air mode. However, do not hang the outdoor
unit onto the indoor unit.
Indication of the fan speed:
= high speed
= average speed
= low speed
FUZZY
= automatic speed
Dehumidifying mode DE-HUM. ( )
Position the indoor unit and the outdoor unit in the
room that is to be dehumidified.
1. Ensure that the indoor unit cannot extract
warm air from the outdoor unit.
2. Do not hang the outdoor unit onto the indoor
unit.
3. Please observe: The condensate formed
during dehumidification may not be pumped
to the outdoor unit as otherwise it will be dis-
sipated back into the air in the room or may
run out of the outdoor unit.
4. Take the condensate drain hose on the back
of the indoor unit out of its bracket and
remove the plug.
5. Allow the condensate to drain downwards
into a drain or container.
NOTICE!
Ensure that the external container does
not overflow. This could result in water
damage.
6. Switch the unit on by means of the "I / 0"
button.
7. Set the temperature selection switch to the
lowest nominal temperature.
8. Set the "MODE" button to the lowest fan
speed "LO".
REMKO RKL
10