Quantum Composers 9500 Plus Series - Manual (Page 61)

57
:PULSe0:OCOunter # Added Off Counts command to set the number of on/Off
pulses to generate in DC Increment mode.
:PULSe0:CYCLe # Added CYCLES command to set the number of cycles to
generate in the DC Increment mode.
:PULSe0:ICLock # Enables/disables the clock input.
:PULSe0:OCLock # Enables/disables the clock output.
:PULSe#:IWIDth # Added IWIDTH command to set the pulsewidth step size.
Range: -0.100000000s – 0.100000000s
:PULSe#:IDELay # Added IDELAY command to set the delay step size.
Range: -0.100000000s – 0.100000000s
Specifications
Width Step Size -100ms to 100ms
Width Minimum Step 10ns (-10ns)
Width Step Resolution 1ns
Width Incremented Range 10,000s
Delay Step Size -100ms to 100ms
Delay Minimum Step 10ns (-10ns)
Delay Step Resolution 1ns
Delay Incremented Range 10,000s
On Pulses (DC Increment Mode) 1,000,000 Pulses
Off Pulses (DC Increment Mode) 1,000,000 Pulses
Cycles (DC Increment Mode)
10,000 Cycles
Update Rate 10us + 30us per active channel
( 1 Ch @ 25kHz to 8 Ch @ 4kHz )
Trigger/Gate Option
The trigger/Gate option adds a second external input to the rear panel of the
9500+ family of pulse generators. The added input is an optoisolated signal that
can be used as a gate or trigger for either the system or the channels. Either
input may be specified as the channel gate input and the remaining input will
then be assigned as the system trigger/gate input. All other 9500+ pulse
generator functionality stays the same.