Quantum Composers 9500 Plus Series - Manual (Page 60)

56
replaces the internal clock and allows multiple pulse generators to share the
same clock.
Function-CLR: Pressing the ‘FUNCTION’ key then ‘CLR’ initializes the
increment parameters and, resets the delays and pulsewidths
to their initial conditions. This must be pressed after setting
all the step parameters, but before generating any pulses.
MENU Additions
Mode Menu
Mode: Added ‘Increment’ and ‘DC Increment’ to mode choices.
CYCLES: Added cycles in the DC Increment mode. (Additional page
available when DC Increment mode is selected.)
Rate Menu
Source: Selects the reference clock source input as either the internal
System clock or an external user supplied reference clock input of
up to10MHz.
Osc Out: Enables/disables the reference clock output. When the Source is
set as External this output contains the external reference clock
input, when the Source is set as System this output contains the To
internal system pulse.
Channel Menu
WidInc: Sets the step size for the pulsewidth increment.
Range: -0.100s to 0.100s (0 = disabled)
DlyInc: Sets the step size for the delay increment.
Range: -0.100s to 0.100s (0 = disabled)
Note: Any increment value > -10ns and < 10ns will disable the increment
function for that parameter.
COMMAND Additions
:PULSe0:MODe Added INCRement and DCINcrement as new
parameters.
:PULSe0:IRESet 1 Added IRESET command to initialize and reset the
increment parameters
: PULSe0:PCOunter # Added Pulse Counts command to set the number of
on/On pulses to generate in DC Increment mode.