Quantum Composers 9500 Plus Series - Manual (Page 50)

46
Keyword
Lower-Level
Keyword
Parameter
Std /
New
Comments
:DISPlay Std Subsystem. Contains commands to control the display.
:MODe 0 / 1 or OFF / ON New
Enables / Disables automatic display update. When
true, front panel display is updated with serial command
parameter changes. Setting to false (0) decreases
response time.
:UPDate? New
Query only. Forces update of display. Use when mode
is false.
:BRIGhtness 0 - 4 New
Controls intensity of display. Range is 0 to 4, where 0 is
off and 4 is full intensity.
NOTE: DISPlay commands are considered irrelevant for the 8510 series.
IEEE 488.2 Common Commands
Mnemonic Command Name Parameter Comments
*IDN? Identification Query
Queries the pulse generator identification. The ID will be in
the following format: model# - #channels - option# -
version#
*RCL Recall Command 0 - 12
Restores the state of the pulse generator from a copy stored
in local nonvolatile memory (0 through 12 are valid
memory blocks).
*RST Reset Command Resets the pulse generator to the default state.
*SAV Save Command 1 - 12
Stores the current state of the pulse generator in local
nonvolatile memory (1 through 12 are valid memory
blocks).
*TRG Trigger
Generates a software trigger pulse. Operation is the same as
receiving an external trigger pulse.
*LBL Setup Label ? or "string value"
The is used to query the label of the last saved or
recalled configuration.
The string must be in double quotes and no longer than 14
characters. Command must be followed by a *sav [1 / 2 / n]
command to take effect. Note: to see the label on the screen
a display update or reboot must take place