Quantum Composers 9500 Plus Series - Manual (Page 49)

45
9500+ SCPI Command Summary
Keyword
Lower-Level
Keyword
Lower-Level
Keyword
Lower-Level
Keyword
Parameter
Std /
New
Comments
:SYSTem Std
:STATe? New
Query Only. Returns the state of
the unit: Returns "1" if the unit is
armed and/or generating pulses
or "0" if the unit has been
disarmed
:BEEPer Std
Subsystem. Controls the audible
beeper.
:STATe 0 / 1 or OFF / ON Std Enables / disables the beeper.
:VOLume 0 - 100 Std
Sets the volume of the beeper.
Range is 0 to 100, where 0 is off
and 100 is maximum volume.
:COMMunicate Std
Subsystem. Controls the RS232
and GPIB interfaces.
:GPIB Std
Subsystem. Controls the
physical configuration of the
GPIB port.
:ADDRess 1 - 15 Std Sets the GPIB of the instrument.
:SERial Std
Subsystem. Controls the
physical configuration of the
RS232 port
:BAUD
4800 / 9600 /
19200 / 38400 /
57600 / 115200 Std
Sets the baud rate for both
receiving and transmitting using
the DB9 RS232 port.
:USB
4800 / 9600 /
19200 / 38400 /
57600 / 115200 New
Sets the baud rate for
communication when using
mapped comports for USB and
Ethernet communication. Must
be set to the default valve
(115200) for raw TCP/IP
communication (i.e. Labview).
:ECHo 0 / 1 or OFF / ON New
Enables / Disables transmission
of characters received on the
DB9 serial port.
:KLOCk 0 / 1 or OFF / ON New Locks the keypad.
:AUTorun 0 / 1 or OFF / ON New
After power-up, the unit will start
generating pulses automatically.
:VERSion? New
Query only. Returns SCPI
version number in the form:
YYYY.V (ex. 1999.0)
:SERNumber? Std
Query only. Returns the serial
number of the unit.