PSE Archery Bow 2012 - Manual (Page 7)

7
installatiOn Of accessOries
Arrowrest/Overdraw: The arrowrest or overdraw should be installed according to the instructions
received with the product. It is usually mounted to the
riser in the threaded hole on the side opposite the shelf
(Hole “A”) using the hardware provided with the arrowrest
or overdraw.
Sight: The sight should be installed according to the
instructions received with the product. It is usually
mounted to the riser in the threaded holes (Holes “B”) on
the side opposite the shelf using the hardware provided
with the sight. Some bows are equipped with multiple
sight mounting holes which allow the sight to be moved
up or down.
Stabilizer: The stabilizer should be mounted according to
the manufacturer’s recommendation. It is usually mounted
in the threaded hole on the front of the riser (Hole “C”).
Bow Sling: The bow sling attaches to the riser of the bow
generally with the stabilizer. If a stabilizer is not used,
attach the sling to the riser with the correct sized bolt
using the hole provided for the stabilizer (Hole “C”).
Other aDjustMents
Draw Weight: Your bow is factory-set to within 2 lbs.
of the peak draw weight indicated on the bow hang tag
and the last 2 digits of the serial number. Changes in
draw weight can be made by turning the limb bolt in or
out. Before making any changes in weight, turn the limb
bolt clockwise to the bottom position. Never use extreme
torque when turning the bolt or damage to the limb may
occur. The limb bolt then may be turned counterclockwise
to obtain the desired weight, but NEVER more than the
number of turns indicated on the hang tag. Adjust each
limb exactly the same.
CAUTION: On some bow models, the limb bolt
locking screw, limb support screws or pocket tang
locking screw MUST be loosened BEFORE adjusting.
Wheels/Cams: Many PSE wheels and cams have
adjustable features. Each one comes from the factory
set up and ready to use but there may be occasions that
you need to adjust the characteristics of your bow. In
some cases you will need a PSE Tune Chart to determine what to adjust, and you may need to
see a PSE Dealer for information. If you are not sure of the adjustment you are making, stop
and see your PSE Dealer for assistance. In many cases, an appropriate bow press will be
needed to make adjustments to cams and wheels. If you do not have an appropriate press,
see your PSE Dealer.
Your authorized Pse dealer is supplied with
technical information on Pse bows and cams.
Please see your dealer for assistance
when making these adjustments.
Hole
A
Holes
B
Hole
C