PSE Archery Prowler Arrow Rest - Manual

1.
Install the Posi-T Key, if riser is so equipped.
2.
Install the arrow rest in this hole using the 5/16-24x ¾” screw
and flat washer provided
3.
Adjust the center shot using adjustment screw “A”. Adjust the
elevation by using screw “B”. Note that there are two threaded
holes in each location to allow for greater adjustment.
4.
1½” below the shelf on the downward-traveling buss cable,
insert the provided rope into the half-way point of the cable
and pull it through leaving a little slack between the cable and
the rest.
5.
Starting about ¼” above the rope, make three overhand
serving knots around the cable only and pull tight.
6.
Tie 3 more serving knots around the cable and rope but do not
cinch tight.
7.
Draw the bow back to full draw. This allows the rope to pull
through the cable to the proper length for initial adjustment.
8.
Pull rope through the cable so that the rope is 1/8” shorter
between the cable and the rest.
PROWLER
TM
DROP-AWAY ARROW REST INSTRUCTIONS
A
B
4
5
6
7
8