PSE Archery Phantom Arrow Rest - Manual

1.
Affix handle pad to riser. Clean riser with alcohol, remove
protective paper from pad and press in place.
2.
Install the Posi-T Key, if riser is so equipped
3.
Install the arrow rest in this hole using the 5/16-24x ¾” screw
and flat washer provided.
4.
Adjust the center shot using adjustment screw “A”. Adjust the
elevation by using screw “B”. Note that there are two threaded
holes in each location to allow for greater adjustment.
5.
With the center-shot and elevation set, the launcher may be
positioned so that it rests against the handle pad. If it does not
make contact, the pad is not needed and may be removed.
6.
1½” below the shelf on the downward-traveling buss cable,
insert the provided rope into the half-way point of the cable
and pull it through leaving a little slack between the cable and
the rest.
7.
Starting about ¼” above the rope, make three overhand
serving knots around the cable only and pull tight.
PHANTOM
TM
DROP-AWAY ARROW REST INSTRUCTIONS
A
B
6
7