Progressive Turf Equipment TDR-22 1393176 and Above - Manual (Page 23)

20
POWER TAKE-OFF
Keep all safety shields in place.
When operating the power take-off, be sure the tractor shield is
always in place, covering the exposed power take-off shaft.
Before dismounting from the tractor, stop the power take-off, put
tractor in neutral, set brakes in lock position and shut off engine.
When ready to engage PTO shaft, be sure engine RPM is at idle
speed. Engaging PTO at full throttle will cause high shock loads
to drive line, with the potential for future failure.
Do not exceed the recommended PTO speed of 540 RPM.
LEVELLING THE MOWER & PTO
For proper mower operation and maximum PTO life, the mower hitch and PTO
driveline must be setup correctly. See illustration on next page
a) When the mower is connected to the tractor, the mower hitch frame “A”
should be as close to level with the ground as possible.
b) The connecting hitch “B” can be removed and turned over to give more height
adjustments. Set in the best position for the mower frame to be as level as
possible.
c) To ensure proper life of the PTO shaft, the driveline from the mower gear box
“D” to the PTO shaft “E” on the tractor should be in a straight line.
d) Spacers “F” are provided under the hose support “C”, to allow adjustment up
or down. Each spacer is 1/2” high. Sixteen are provided, for a 2” total
adjustment, four on each corner.