Progressive Turf Equipment TDR-22 1393176 and Above - Manual (Page 14)

11
 Do not use the mower in limited visibility (e.g. at dusk, in fog, heavy rain etc.). Mow
only in daylight or good artificial light.
 Disengage PTO and ensure blades are completely stopped before raising wings.
 Ensure transport locks are securely engaged before transporting mower with wings in
raised position.
 Clean reflectors, Slow Moving Vehicle sign and lights before transporting. Use power
unit hazard lights.
 Before disconnecting from power unit, always lower equipment to the ground, place
controls in neutral, set park brake, turn engine off, and wait for all moving parts to stop.
Relieve hydraulic pressure per power unit manufacturer’s instructions.
 Ensure mower tongue jack is securely fastened to mower frame with supplied pin
before removing hitch draw pin.
MAINTENANCE SAFETY PRECAUTIONS
 Never make adjustments or repairs with the engine running. Always disengage PTO,
turn engine off, lower wings to cutting position and relieve hydraulic pressure before
performing any maintenance.
 Observe and perform proper lock-out procedures for power unit if attached to mower
during service.
 Keep nuts and bolts tight and properly torqued, especially blade attachment bolts.
Check that all cotter pins are properly installed. Keep equipment in good condition.
 Keep mower free of grass, leaves, or other debris build-up.
 Never work on raised mower decks without safety locks in place.
 Periodically check condition of safety devices, guards, and deflectors. Replace only
with manufacturer’s recommended parts.
 Inspect and replace damaged blades. Use only original OEM parts. Blades can fail from
poor maintenance practices.
 Handle mower blades carefully. They are sharp and can cut unprotected skin. Use
caution and wear gloves when handling them.
 Check to make sure hydraulic hoses are not worn or damaged, and are routed to avoid
chafing.
 Immediately replace any hydraulic hose that shows signs of swelling,
wear, leaks or damage so it does not burst.
 Do not use your hand to check for hydraulic oil leaks. Use a piece of
cardboard instead. Hydraulic fluid escaping under pressure can
penetrate the skin causing serious injury. If skin penetration occurs,
seek medical attention immediately. Relieve all pressure before
disconnecting hoses.
 Do not bend or strike hydraulic lines, tubes or hoses, or reinstall them in
a bent or damaged condition.