Progressive Turf Equipment TDR-22 1393176 and Above - Manual (Page 19)

16
ASSEMBLY INSTRUCTIONS
SET-UP
The mower is shipped in a 90% assembled condition to facilitate shipping of the
mower in enclosed vans. Approximately 1 1/2 hours are required to complete the
mower to field ready condition. Assembly will be easier if components are aligned
and loosely assembled before tightening hardware. Recommended torque values are
found on page 34. Select a suitable working area. A tractor or portable hydraulic
supply is necessary to complete assembly.
Always use personal protection devices such as eye and ear
protection during assembly. Ensure the area is free of hazards
and can accommodate the assembly of the mower
WING DECKS
1. Before removing any bolt or pin, the deck spreader fixture (PTE # 526498)
needs to be placed underneath the mower frame, centered between the wing
decks on the floor, see photos below. This must be installed before lowering
the decks to prevent the decks from pivoting underneath the mower frame.
FIG. 2 FIG. 1