Posiflex JIVA XT-3114 - Manual (Page 13)

Part 13
manual, this switch will always turn the system on when activated, but will not
power off the system when tapped again (the forced power off feature will not
work in this mode). When using this feature, please make sure that the
software application has the ability to power off the machine. In preloaded
Windows, “Posiflex Power Switch Manager” in “Posiflex Tools” in the
Program Files helps managing these functions.
Software Support Features
The XT series provides a software power off command for application
program maneuvers. The XT also provides a specific means for the software to
detect if the system is working on external or UPS battery power. Due to this
feature, compatible software applications have the ability to change operating
conditions when running on standard/backup power. The software programmer
may take reference from the KS technical manual to apply such features.
Automatic Power on Control
The XT system may also turn on according to some preset conditions such as
Alarm Clock Wake Up or LAN Wake Up.
To utilize Alarm Clock Wake Up function, the user should enter the BIOS
setup by pressing “Del” key at system boot up, choose in “Power Management
Setup” and enable the “Resume by Alarm” for Alarm Clock Wake Up. Save
the configuration and exit the BIOS setup program. The Preset Power On
Control will then be ready. For LAN wakeup, the item “PCI Express PM
Function” must be enabled in “Power Management Setup” and an operating
caller system connected through LAN to the system is required. It also requires
a qualified networking technician to check the LAN chip ID of the system for
the caller system to wake up.
When the XT system is turned off after a successful boot up, the preset
automatic power on functions will keep monitoring for the preset
conditions]and turn on the system when the preset conditions are met.
Please note that if the XT system is improperly turned off before a complete
boot up procedure, the above preset power on control functions will be
disabled until next turning off after a complete boot up.
Note: Eup standard is not supported for LAN wake-up enablement.