Posiflex JIVA XT-3114 - Manual (Page 10)

Part 10
Hold them together with a cable tie. Pass all cables through the cable exit to
external connections.
SIDE MOUNT UPGRADE KIT
Remove the 2 circled screws in the right picture
above to remove the cover for side mount
upgrade kit. Take out the cable inside this cover
as circled in the right picture and connect it to
connector inside the side mount upgrade kit as
arrowed in the same picture. Gently arrange the
excessive length of this cable back in the hole and screw-fit it back to the
position originally occupied by the cover. Please reserve the cover if there is
chance to have the side mount kit removed in the future.
BASE MOUNT UPGRADE KIT
Please follow the instructions on the manual that comes along with the
2
nd
customer display LM-3010/LM-3014 if installed.
1. For Second LCD Display
There are LM-3010/LM-3014 available for 2
nd
LCD
display, needed to combine with XT3114 with
supporting bracket to tighten.
Please refer to the following steps to assemble properly.
Please take out the join bracket and use the attached 4
pcs long screws to fasten this bracket to the main unit
back cover which is circled in the right picture.
Next, please connect the VGA Cable to the LM VGA
port and route the VGA cable through the cable exit of the
base stand to the system VGA ports.
Note: When XT-3114 series equipping with LM-3010/3014 series second
LCD monitor, system power adaptor must be upgraded from 60W
to 80W (or kept as 60W) .