Posiflex JIVA XT-3114 - Manual (Page 11)

Part 11
CONNECTING CASH DRAWER (OPTIONAL)
The RJ11 connector in I/O area of a XT-3114 system can be used for
controlling most of the common cash drawers available on the market.
However, it is most recommended to use Posiflex CR-2200 or CR-2210 or
CR-3100 or CR-4000 or CR-4100 or CR-6300 for best compliance to operate
the opening mechanism and to monitor the drawer open status.
This cable of Cash Drawer has a 6-pole plug at one end and an 8-pole plug at
the other. The 8-pole plug should be inserted into the connector of the cash
drawer which marked “Signal”. The 6-pole plug should be inserted in the
connector marked “CR” which can found in the main connection area in the
system.
The user may also purchase the optional 2-in-1 cash drawer control cable to
control 2 cash drawers in 1 port. It has a 6-pole plug at one end and two 8-pole
plugs at the other. The 6-pole plug should be inserted in the connector marked
“CR” found in the I/O area in the system. Each 8-pole plug should be inserted
into the connector marked “signal cable from POS Printer” at the rear of one of
the cash drawers.
OPERATING SYSTEM INSTALLATION
This product is highly professionalized equipment. The installation of an OS
into a machine without any preloaded OS could be a major difficulty for
average user or obstacle by possibly unintentional negligence even for PC
veterans to accomplish such a task. Therefore, OS installation into a system
without preloaded OS is highly discouraged. Posiflex Technology, Inc. shall
not be responsible for any technical support to questions on this aspect.
APPLICATION ENVIRONMENT
It is very important that you check the following operational guidelines:
Ventilation
This terminal must NOT be operated in an environment with restricted
ventilation. There must be at least 25 mm air clearance around any top or side
ventilation holes with a free flow of air around the unit at ALL times for the
installation.
Operating Environment
The equipment must not be operated or stored in extremes of both temperature
and humidity/moisture. (Operating range 0°C to 40°C and up to 80%
humidity – non condensing, max. wet bulb 26°C)