Posiflex FT-7715 - Manual (Page 16)

Part 16
mode. If there appears to be some serious trouble for system restart or even
this emergency power off, please disconnect the UPS battery if installed and
the AC power supply for few minutes. This may allow all hardware registers to
reset.
DISPLAY ISSUES
LCD / Touch Panel Tilt Adjust
Please find the rectangular plastic button at rear of the display base as
enlarged in the right picture
Push it down (from back of the
panel towards the front side) to
adjust the display up and down.
Release the button when done.
The panel will lock firmly for
application.
LCD Panel Brightness Adjust
There are 2 LCD panel brightness control buttons
on front side of base for digital control over the LCD
panel brightness. A brief touch at the right / left button
makes the LCD display brighter / dimmer by a minute
amount. A holding touch makes continuous change till
release.
Main LCD Display
For best viewing result please set your display resolution at 1024 x
768 with high color for FT-7715.
In configuration of 4GB system memory installed, max. 1.7 GB can
be shared as the video memory under the preloaded 64-bit operating system
condition.
VGA Port
The VGA port in the FT system supports Posiflex LCD monitor or
touch monitor for 2
nd
display. This port supports either mirror mode (identical
image) or extended mode dual display function for WinXP. To support the DC
power to the stand alone Posiflex monitor, use the DC adaptor to connect into
the monitor or use Posiflex VGA + power cable and set an internal jumper in
FT main board to supply the required power through the VGA connector. Do
not connect other monitor to this port before the power in this port is
disabled.