Paso Sound DMA2015 - Manual (Page 30)

PAGE 30
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
PROFESSIONAL AUDIO & SOUND
®
DIGITAL MUSIC AMPLIFIERS
DMA2015/2030/2060/2120
SATELLITE RECEIVER MUSIC AND MESSAGES ON HOLD - APPLICATION DATA 125
APPLICATION
The Satellite Receiver may be configured to provide Music
Output (MAIN AUDIO OUT) and Messages on Hold
(OPTIONAL AUDIO OUT) if equipped with an LE CARD OR
MESSAGES ON HOLD CARD.
The PASO DMA SERIES Amplifiers can provide both
Outputs from the Encompass Receiver to be independently
routed:
1) Music Output to the 25/70 Volt (or 8 ohm) Main Speaker
Output.
2) Messages Out to the Telephone System Music on Hold
Output.
WIRING
A Wiring Diagram is provided on page 2.
NO INTERNAL JUMPERS RE-SETTING IS REQUIRED.
Use the factory default settings.
A) By using a pair of Audio Cable terminated with standard
RCA Plugs connect the Main Audio Output (MUSIC) to Input
4 - AUX 2 (REF. 15) of the Amplifier.
B) By using a pair of Audio Cable terminated with standard
RCA Plugs connect the Optional Audio Output (MES-
SAGES) to Input 3 - AUX 1 (REF. 16) of the Amplifier.
C) Connect the Music on Hold Input of the Telephone
System to the MOH 0 and 600 ohm Output Terminals (REF.
3) of the Amplifier.
CONTROLS SETTING
BE SURE THE AMPLIFIER AND THE ENCOMPASS UNIT
ARE OFF.
a) Set Front Panel Controls INPUT 1/MIC, TEL, INPUT
3/AUX 1 AND INPUT 4/AUX 2 to Zero (fully counterclock-
wise).
b) Set Input 4 - AUX 2 Attenuator on rear panel (REF.14) to
the 1 o’clock position.
c) Set Input 3 - AUX 1 Attenuator on rear panel (REF.17) to
ZERO.
d) Set MOH Level on rear panel (REF.1) to ZERO.
Be sure all wiring and connections have been made. Turn
both the Encompass and the Amplifier ON.
e) Slowly turn the INPUT 4/AUX 2 Volume Control clockwise
(MUSIC) on the front panel until the desired Output Music
Level has been achieved. If the Music Output Level is insuf-
ficient raise the INPUT4/AUX2 Attenuator another 1/4 of a
turn.
f) MOH - By listening through a Handset slowly turn the
MOH LEVEL Control clockwise (REF. 1) on the rear panel
until the proper level for the Messages is achieved.
PAGING FROM A MICROPHONE
PRIORITY PAGING MICROPHONE - A Low Impedance
Paging Microphone may be connected to the INPUT 1 of
the Amplifier. The Amplifier is preset to mute the Music on
Input 4 when the Paging is activated.
PAGING LEVEL
The Microphone Paging Output level is set by the INPUT 1
Level Control located on the Front Panel.
PAGING FROM THE TELEPHONE
PRIORITY TELEPHONE PAGING - A Telephone Paging
Output may be connected to the TEL Input of the Amplifier.
The Amplifier is preset to mute the Music on Input 4 when
the Telephone Paging is activated.
PAGING LEVEL
The Telephone Paging Output level is set by the TEL Level
Control located on the Front Panel.
VOX SENSITIVITY ADJUSTMENT
The rear panel control marked VOX SENS sets the sensitiv-
ity of the VOX when Paging. While Paging (from either the
Microphone or the Telephone) turn the VOX SENS Control
slowly clockwise until the Music is muted.
NOTE: The Paging from the Microphone or the
Telephone will NOT be routed to the the MOH Output.