Paso Sound DMA2015 - Manual (Page 22)

PAGE 22
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
PROFESSIONAL AUDIO & SOUND
®
DIGITAL MUSIC AMPLIFIERS
DMA2015/2030/2060/2120
INSTALLING AND USING A BOSE® SYSTEM 32 EQUALIZER MODULE PASO MODEL PMEQ32B
THE FOLLOWING INSTRUCTIONS REQUIRE THE REMOVAL OF THE AMPLIFIER TOP COVER AND ARE PROVIDED FOR USE BY
QUALIFIED PERSONNEL ONLY. TO AVOID THE RISK OF ELECTRICAL SHOCK DO NOT PERFORM ANY INSTALLATION OR SER-
VICING UNLESS YOU ARE QUALIFIED TO DO SO. REFER INSTALLATION OR SERVICING TO QUALIFIED PERSONNEL.
CAUTION ! REMOVAL OF THE AMPLIFIER COVER PRESENTS AN ELECTRICAL SHOCK HAZARD
ALWAYS REMOVE THE POWER CORD FROM THE AC WALL OUTLET
POWER
O
INPUT 1/MIC TEL INPUT 3/AUX 1 INPUT 4/AUX 2
10 0 10 0 10 0 10 0
DIGITAL MUSIC AMPLIFIER
DIGITAL MUSIC SERIES
TM DMA
BASS TREBLE
+10 -10 +10 -10
0 0
PROFESSIONAL AUDIO & SOUND
TOP COVER
PMEQ32B
ACCESS TO THE EQ SOCKET
ACCESS TO THE INTERNAL EQ
MODULE SOCKET
1) Remove the Power Cord from the
AC Outlet.
2) Remove the three screws on each
side of the Amplifier securing the Top
Cover to the Chassis.
3) Lift Cover and carefully slide Cover
out towards the rear.
4)
Locate the Socket marked EQ
MODULE on the Main Printed Board.
OPTIONAL
EQ CARD
SOCKET
CN 210 EQ MODULE
CHIME MODULE
OPTIONAL
CHIME CARD
SOCKET
CN 209
AMPLIFIER REAR PANEL
EQ CARD SOCKET
INSTALL THE MODULE
1) Procure the PASO Model
PMEQ32B Module for the BOSE 32
Speaker System.
2) Line-up the “
NOSE” of the Module
with the Keyway of the Socket on the
Main Printed Board.
3) Press the Module
gently into the
Socket (do not force).
4)
Replace Amplifier Top Cover.
SETTINGS
PRIOR TO TURNING AMPLIFIER
ON SET THE FOLLOWING:
1) Set the EQ LINK Switch
Reference 22 on the rear panel to
EXTERNAL (EQ Module Active).
2) Set the TONE BY-PASS Switch
Reference 18 on the rear panel to
the ON position (Front Panel BASS
and TREBLE Controls defeated).
3) Attach the PMEQ32B Silver
Label, packed with the module, on
the rear panel to indicate that the
module is installed inside.
AUX 1
47 Kohm 250 mV
INPUT 3 (MIC-AUX1)
15W RMS
AUX 2
47 Kohm 250 mV
INPUT 4 (MIC-AUX2) INPUT 1 (MIC)
(AUX 2)
ATTENUATOR
(AUX 1)
ATTENUATOR
INPUT 4 INPUT 3
VOX
SENS
MUTE
DELAY
3 - 60 SEC
8 OHM
2 Watt Max.
SP
INPUT 1 MAY BE
TRANSFORMER
BALANCED
WITH OPTIONAL
MODEL MT250 DMA2015
24 V DC
250 MA
- +
DMA2015 Rear Panel
Manual
18
22
Attach Silver Label packed with module
IMPORTANT NOTE
The PASO Module PMEQ32B
can be used only with the fol-
lowing PASO Amplifier Models:
DMA2015 - DMA2030
DMA2060 - DMA2120
DMA3060 - DMA3120
Fig. 22 - PMEQ32B Installation Diagram