Paso Sound DMA2015 - Manual (Page 23)

PAGE 23
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
PROFESSIONAL AUDIO & SOUND
®
DIGITAL MUSIC AMPLIFIERS
DMA2015/2030/2060/2120
INSTALLING AND USING THE CHIME MODULE PASO MODEL AC1B/DMS
ACCESS TO THE CHIME SOCKET
ACCESS TO THE INTERNAL
CHIME MODULE SOCKET
1) Remove the Power Cord from the
AC Outlet.
2) Remove the three screws on each
side of the Amplifier securing the Top
Cover to the Chassis.
3) Lift Cover and carefully slide Cover
out towards the rear.
4)
Locate the Socket marked
CHIME MODULE on the Main Printed
Board.
OPTIONAL
EQ CARD
SOCKET
CN 210
EQ MODULE
CHIME MODULE
AMPLIFIER REAR PANEL
OPTIONAL
CHIME CARD
SOCKET
CN 209
CHIME CARD SOCKET
INSTALL THE MODULE
1) Procure the PASO Model
AC1B/DMS Chime Module
2) Line-up the “
NOSE” of the Module
with the Keyway of the Socket on the
Main Printed Board.
3) Press the Module
gently into the
Socket (do not force).
SETTINGS
PRIOR TO TURNING AMPLIFIER
ON SET THE FOLLOWING:
1) Set the Chime Module Output
Level Control Trimmer approx. 1/4
of a turn clockwise.
2) Replace Amplifier Top Cover.
3) Turn Amplifier ON and momen-
tarily short the Terminal MUTE
(Reference 5) to Terminal G
(ground). The Chime should sound.
4) If the Chime level needs to be
reset, turn Amplifier OFF, remove
cover and adjust the Chime
Trimmer accordingly.
AUX 1
47 Kohm 250 mV
INPUT 3 (MIC-AUX1)
15W RMS
AUX 2
47 Kohm 250 mV
INPUT 4 (MIC-AUX2) INPUT 1 (MIC)
(AUX 2)
ATTENUATOR
(AUX 1)
ATTENUATOR
INPUT 4 INPUT 3
VOX
SENS
MUTE
DELAY
3 - 60 SEC
8 OHM
2 Watt Max.
SP
INPUT 1 MAY BE
TRANSFORMER
BALANCED
WITH OPTIONAL
MODEL MT250 DMA2015
24 V DC
250 MA
- +
DMA2015 Chime Activation
5
CHIME ACTIVATION SWITCH
OFF
ON
IMPORTANT NOTE
The PASO Module AC1B/DMS
can be used with the following
PASO Amplifier Models:
DMA2015 - DMA2030
DMA2060 - DMA2120
DMA3060 - DMA3120
THE FOLLOWING INSTRUCTIONS REQUIRE THE REMOVAL OF THE AMPLIFIER TOP COVER AND ARE PROVIDED FOR USE BY
QUALIFIED PERSONNEL ONLY. TO AVOID THE RISK OF ELECTRICAL SHOCK DO NOT PERFORM ANY INSTALLATION OR SER-
VICING UNLESS YOU ARE QUALIFIED TO DO SO. REFER INSTALLATION OR SERVICING TO QUALIFIED PERSONNEL.
CAUTION ! REMOVAL OF THE AMPLIFIER COVER PRESENTS AN ELECTRICAL SHOCK HAZARD
ALWAYS REMOVE THE POWER CORD FROM THE AC WALL OUTLET
Fig. 23 - AC1B/DMS CHIME MODULE
Fig. 23A - AC1B/DMS Wiring Diagram
OUTPUT LEVEL TRIMMER