Paso Sound DMA2015 - Manual (Page 26)

PAGE 26
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
INSTALLATION AND WIRING
USING SPEAKERS FOR ZONE 1 OUTPUT
15W RMS
VOX
SENS
MUTE
DELAY
3 - 60 SEC
8 OHM
2 Watt Max.
SP
DMA2015
24 V DC
250 MA
- +
4
ZONE 1 OUTPUT LEVEL CONTROL
AWG 18
TWISTED PAIR
Up to Four 8 ohm Speakers may
be Connected
1/2W
1/2W
1/2W
1/2W
8
OHM
ZONE 1
4 Speaker System Max. Power Output= 1/2W Each
8
OHM
8
OHM
8
OHM
MOH - ZONE 1
INPUT SOURCE
DEFAULT JUMPER
SETTING
DMA2015 Zone 1
AUX1 AUX2
S107
8
Fig. 26 - Rear Panel Zone 1 Speaker Connection Diagram
ZONE 1 OPERATION
The Amplifier is equipped with a 2 Watt, 8 ohm Outputs des-
ignated ZONE 1 (Reference 4). The Output may be utilized
to power up to 4 speakers in various combinations as
described in the diagrams on the next page. This feature will
provide a SECOND ZONE (in addition to the main output)
with up to 2 Watt of output power and will amplify only the
Source from either AUX 1 or AUX 2 (see input source selec-
tion) and will not be affected by the Paging (from MIC or
TEL), VOX or MUTING.
It can be used in any area (up to 2 Watt) where only a
Program Source is desired uninterrupted by Paging.
CABLE
Use an AWG 18 jacketed, twisted pair cable.
ZONE 1 OPERATION ZONE 1 SETTINGS
INPUT SOURCE SELECTOR
Independent JUMPER SETS for ZONE 1 (S107) is avail-
able to select the Input Source for the 2 Watt Amplifier.
Select the Input Source desired by following the instructions
in the MOH Amplifier Source Selection section.
LEVEL CONTROL
After the wiring is completed adjust the ZONE 1 (
Reference
8) Level Control on the rear panel to the desired output
level.
PROFESSIONAL AUDIO & SOUND
®
DIGITAL MUSIC AMPLIFIERS
DMA2015/2030/2060/2120