beautypg.com

Digital music amplifiers, External – Paso Sound DMA2015 User Manual

Page 20

background image

PAGE 20

SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE

INSTALLATION AND WIRING

CONNECTING TO AN EXTERNAL EQUALIZER
The Amplifier is equipped with an External Equalizer Link
to allows the use of an External Equalizer for applications
requiring

Frequency Selective Acoustic Correction. The

Amplifier is furnished with the two jacks of the Link bridged
by a SELECTOR SWITCH. When the EQ LINK Switch
(REFERENCE 21)
is the EXTERNAL position the internal
Preamplifier to Amplifier Link (Reference 21) is broken
allowing the insertion of an External Equalizer.

INSTALLATION TIPS

1) Use high quality, short length audio cables and position
the Equalizer in close proximity to the Amplifier. Avoid
mounting the EQ on top of the Amplifier unless is Rack
mounted.
2) Be sure that the Amplifier input controls and the EQ level
control are set at zero prior to turning the system On.
3) The Amplifier TONE BY PASS SWITCH (Reference 18)
should be set to ON ( linear response position).
4) Carefully adjust the EQ Level Control to avoid distortion
caused by excessive signal boost.
5) Follow the instructions supplied with the Equalizer.

WIRING
To connect to an External Equalizer use two (2) single con-
ductor shielded audio cables terminated in a single prong
phono plug on both ends.

DMA2015 EQlink

EXTERNAL EQUALIZER

paso

To Input of Equalizer

To Output of Equalizer

22

21

EQ LINK

EXTERNAL

INTERNAL

PRE

OUT

POWER

IN

EQ LINK

18

ON

OFF

TONE

BYPASS

EXTERNAL EQUALIZER LINK

SET EQ LINK SWITCH TO

EXTERNAL

EXTERNAL EQUALIZER LINK

Fig. 20 - Rear Panel External Equalizer Link Diagram

DMA2015 Mixbuss

19

ON

MIX

BUSS

LINE OUT

600

19

ON

MIX

BUSS

LINE OUT

600

AMPLIFIER A

AMPLIFIER B

MIX BUSS BRIDGING

Fig. 20B - Rear Panel Mix Buss Bridging Diagram

BRIDGING TWO AMPLIFIERS

The MIX BUSS (Reference 19)
allows two Amplifiers to be bridged
and share all inputs.

All signal sources connected to all
the inputs are common to the output
of both amplifiers. Muting and level
controls operate in exactly the same
way as if only one amplifier was
used.

MIX BUSS BRIDGING

WIRING

CABLE
To bridge two amplifiers or to con-
nect to an external Mixer use a sin-
gle conductor shielded audio cable
terminated in a single prong phono
plug on both ends.

SET TONE BY PASS SWITCH TO

ON

PROFESSIONAL AUDIO & SOUND

®

DIGITAL MUSIC AMPLIFIERS

DMA2015/2030/2060/2120

This manual is related to the following products: