OWON ODP Series - Manual (Page 25)

5.Front Panel Operation
20
status. If turn on the timing output, the system will output the pre-set parameters between
0 and the set number at sequence or loop mode.
(1) In timer status:
 Independent Mode
Press the System key, enter [System
→ CH1 (CH2) →TimerRng].
 Parallel, Series Mode
Press the System key, enter [System
→ TimerRng].
 Plus-minus Mode
Press the System key, enter [System
→ Positive →TimerRng].
(2) The timer range setting box pops up. Use the numeric keys enter a number (0~99),
press the
▲ / ▼ key to switch between Sequence and Loop, press the
key to
confirm.
5.4.4 Turn On/Off Timing Output
In timer status:
 Independent Mode
Press orange ON/OFF key to turn on/off the timing output of Channel 1.
Press blue ON/OFF key to turn on/off the timing output of Channel 2.
 Parallel, Series or Plus-minus Mode
Press orange ON/OFF key to turn on/off the timing output.
Note:
In the process of timing output, closing the channel output will reset the timer; turning on
the channel again will restart the timing output and the timer.
5.5 Save/Recall/Record
ODP Series support operations with a USB flash device and local file storage, including:
store, recall and delete current setting parameters. The current data of the channel can be
recorded into a txt file, which stored in USB disk. You can connect the USB disk to the ①
USB Host interface in Figure 4-2. After connecting the USB disk successfully, an icon
will be shown at the top of the screen.
5.5.1 Save System Parameters
In Normal Status, press the Save key to save the parameters about current working mode
and the output voltage/current, the O.V.P/O.C.P of current mode. You can name the setting
files. This function is not available in Timer Status.
(1) In Normal Status, press the Save key to enter the function interface (press it again to
exit). Press the
▲ / ▼ key to choose the storage location as "Local" or "UDisk". Turn