OWON ODP Series - Manual (Page 21)

5.Front Panel Operation
16
5.1 Turn On/Off the Channel Output
 Independent Mode
Press the orange ON/OFF key to turn on/off the Channel 1 output.
Press the blue ON/OFF key to turn on/off the Channel 2 output.
The ON/OFF key is lighted when the corresponding channel is on.
 Parallel, Series and Plus-minus Mode
Press the orange ON/OFF key to turn on/off the channel output.
The blue ON/OFF key is invalid.
5.2 Set the Output Voltage/Current
You can set the output voltage/current through input box. About the rated range of each
mode, please refer to "Icons and Ratings" on P13.
Note: The output voltage/current cannot be set in Timer status. If you want to set it, you
should exit the Timer status first.
 Independent mode
(1) Press the orange Volt/CV or Curr/CC key, the input box of Channel 1 output
voltage/current will pop up.
(2) The key light will start blinking, indicating to input, there are two methods to
change the value.
Modify: Turn the knob or press the
▲ / ▼ direction key to change the value by
the unit of cursor position, hold down the
▲ / ▼ direction key to change
continuously. Press the ＜ / ＞ key to move the cursor.
Input: Use the numeric keys to enter a desired value, the original value will be
cleared, and display the value you entered.
(3) Press the key to confirm.
In the same way, press the blue Volt/CV or Curr/CC key to set the output
voltage/current of Channel 2.
 Parallel/Series mode
(1) Press the orange Volt/CV or Curr/CC key, the input box of output
voltage/current will pop up.
(2) The operation of input box is the same as Independent mode.
 Plus-minus mode