OWON ODP Series - Manual (Page 24)

5.Front Panel Operation
19
5.4.2 Timer Setting
Before turning on the timing output, you should set the timer parameters, including
voltage, current and output time. This function allows up to 100 groups of timer
parameters.
In timer status, press the Set key to enter/exit timer setting interface of the current mode.
Press the Mode key to switch between the corresponding timer setting interface of the
four working mode.
Number Voltage Current
Output
time
Channel 2
Editing value
Page number
Channel 1
(same layout as Channel 2)
Figure 5-1 Timer Setting Interface in Independent Mode
The selected parameter will be highlighted.
In Independent mode or Plus-minus mode, press orange ON/OFF key to select the left
parameter area, press blue ON/OFF to select the right parameter area.
Press the
▲ / ▼ key to change the parameter item.
After selecting the parameter, use the numeric keys to enter a desired value, press the
key to confirm.
Press the ＜ / ＞ key to go to the previous or next setting page.
Note:
● If the input value exceeds the rating of current working mode, the system will change it
to the maximum rating automatically after pressing the key to confirm.
● In the Plus-minus mode, the values of the Negative and Positive output time remain
consistent, you can set either of them.
5.4.3 Timer Range
Timer range setting denotes that you can set the last number of timer parameter group and
output mode. You can find out the TimerRng submenu of system menu only in timer