Orion System OE217-00 - Manual (Page 19)

JOB NAME
FILE NAME
PAGE DESCRIPTION
OE265-13 BAPI
Outside Air Humidity Sensor – 0-5 VDC
DRAWN BY: B. CREWS
2 of 2
Notes:
1.) All Wiring To Be In Accordance With Local And
National Electrical Codes And Specifications.
RH Output
% VDC
55 ........ 2.75
60 ........ 3.00
65 ........ 3.25
70 ........ 3.50
75 ........ 3.75
80 ........ 4.00
85 ........ 4.25
90 ........ 4.50
95 ........ 4.75
100 ........ 5.00
RH Output
% VDC
5 .......... 0.25
10 .......... 0.50
15 .......... 0.75
20 .......... 1.00
25 .......... 1.25
30 .......... 1.50
35 .......... 1.75
40 .......... 2.00
45 .......... 2.25
50 .......... 2.50
Humidity Sensor
RH/Voltage Chart
Warning
Be Sure To Observe
Polarity Or Serious
Damage To The
Board Could Result
0-5 VDC Output Wiring (24VAC Power)
*Chart Notes:
1. First, be sure that +24VAC power is being supplied to the sensor. Second check the
sensor output. Set the meter to DC volts and connect the meter between ground
and the 0-5 VDC input terminal on the controller board or between the 0-5 VDC
output on the sensor and its ground wire or you can measure voltage at the 0-5 VDC
and GND terminals on the sensor located at the sensor installtion location.
After measuring the voltage use an accurate humidity measurement device to
determine RH (relative humidity) such as an aspirating psychrometer. Use the
Output VDC column to read the Output Voltage corresponding with the RH
percentage measured with the psychrometer. If the measured voltage is within 3%
of what is listed for the corresponding RH, then the sensor is functioning properly.
CONNECT TO
24 VAC POWER
G-OE265-13B-OAHUMID-1F.PDF
DATE: 08/25/11
0-5VDC
Terminal
Label:
LB101966 RED BLK WHT
Not
Used
VA
Co
rD
C
GND 0-5V
SENSOR TERMINAL
BLOCK