OpenEye CA-501J PTZ - Manual (Page 28)

14 28563AA
Exiting Tour Mode
Press the ESC key to exit the Tour mode after configuring a tour line.
AUTO SCAN
You can control the Auto Scan function of a dome camera under the Camera Control mode; one auto scan line can be set using the
keyboard.
Setting an Auto Scan Line
1. Press the AUTO SCAN key to enter Auto Scan mode. The LCD screen will display 1.RUN 2.SETTING.
2. Press 2 to configure the Auto Scan parameters.
3. Move the dome camera to the desired position and press ENTER to save it as the start position.
4. Pan the camera to the next position and press ENTER to save it as the end position.
5. Select the scan direction (RIGHT/LEFT) using the direction keys and then press ENTER.
6. Select the speed (1-4) using the direction keys and then press ENTER.
Executing the Auto Scan Line
1. Press the AUTO SCAN key to enter Auto Scan mode. The LCD screen will display 1.RUN 2.SETTING.
2. Press 1 to run the Auto Scan function.
3. Press ESC to exit the auto scan mode.
PATTERN
Setting the Pattern Path
1. Press PATTERN to enter the Pattern mode. The LCD screen will display 1.RUN 2.SETTING.
2. Press 2 to configure the Pattern path.
3. When the LCD screen displays ENTER for Start Pos. press ENTER and use the joystick to rotate the camera and form a
pattern path.
4. Press ENTER to set the Pattern end position.
5. When the LCD screen displays ENTER for Saving press ENTER to save the pattern path.
Executing the Pattern Path
1. Press PATTERN to enter the Pattern mode. The LCD screen will display 1.RUN 2.SETTING.
2. Press 1 to run the Pattern path.
3. Press ESC to exit the Pattern mode.