OpenEye CA-501J PTZ - Manual (Page 22)

8 28563AA
Standby Mode Actions
You can perform the following actions while in Standby Mode.
• Press the SYS key to enter System Setup mode.
•
Press the CAMERA key to enter Camera/Dome Control mode and access the camera OSD setup and PTZ operations.
• Press the DVR key to enter DVR mode.
KEYBOARD SYSTEM SETTING
Detailed operation of the system settings are described in the following sections. Please use RUN TOUR ( Ÿ) and SET TOUR ( ź)
keys to scroll through the setup items.
Press the SYS key to enter System Setup mode. The default password is 0000
1.1 SYSTEM LINKING
System linking allows users to scan connected dome cameras on the RS-485 bus – fixed cameras will not be located.
Press the Ż or Ź key to start a new scanning session.
NOTE: This feature is only available on OPTIX 3 compliant domes.
1.2 KEYBOARD ID ASSIGNMENT
Keyboard ID Assignment allows users to assign a new ID to the keyboard – the default ID is 240. Assign a different ID to each
keyboard if more than one keyboard is connected to an RS-485 bus.
NOTE: No two keyboards connected to the same RS-485 bus should be assigned the same ID>
Press the Ż or Ź key to change the ID number
1.3 SYSTEM MONITOR
The System Monitor settings are for factory use only – do not change.
1.4 RS-232 BAUD RATE SETTING
Users can select the RS-232 baud rate when needed:
a. Baudrate 9600bps
b. Baudrate 4800bps
c. Baudrate 2400bps