OpenEye CA-501J PTZ - Manual (Page 27)

28563AA 13
TOUR FUNCTION
In Camera Control mode, you can operate the tour function. Before setting this function, you must pre-define at least two preset
positions. Up to eight tour lines can be set using the keyboard controller.
Set Tour Line
TIP: Each Tour Line can be composed of up to 32 preset positions.
1. Press a number key to assign a tour number.
2. Press the SET TOUR key to modify the tour parameters.
001 PST SPD DWELL
[004] [15] [005]
001 – The serial points of a tour line (001~032)
PST – Preset Points (1~128)
SPD – Speed (1~15)
DWELL – Dwell Time (1~127 seconds)
DESCRIPTION: The first preset point for tour 1 is preset position 4. The dome camera will stay at that position for 5 seconds and go to
the next point at speed 15.
3. Press the number keys (1~128) to assign the first preset position and then press ENTER.
4. Press the number keys (1~15) to assign a camera speed and then press ENTER.
5. Press the number keys (1~127) to set the dwell time in seconds and then press ENTER.
6. Repeat the steps above to add additional tour lines and press SETUP when finished.
TIP: Press RUN TOUR and SET TOUR to scroll up and down all pages. You can also press SET PRESET and GO PRESET to move
the cursor.
Execute Tour Function
Press a number key to specify a Tour line and then press RUN TOUR.
Insert or Delete Point
Users can insert or delete one of the serial points from a Tour line easily.
• Press the AUTO SCAN key to insert a point.
• Press the PATTERN key to remove a point.
EXAMPLE - To insert Preset position 4into the second position of Tour1( that already includes Preset positions 1, 2, 3, 4, and 5):
1. Press 1 and then press the SET TOUR key to open the tour
menu. 001 PST SPD DWELL
[001] [15] [005]
2. Scroll down to PST 2 and then press the AUTO SCAN key;
the LCD screen will display Inserting Point… 001 PST SPD DWELL
[002] [15] [005]
3. Scroll down to PST 4 and press ESC. 001 PST SPD DWELL
[004] [15] [005]
4. The points of Tour 1 should now be PST 1, 4, 2, 3, 4, and 5. Press the RUN TOUR key to check the tour sequence.