OnLine Power Protector 3 - Manual (Page 8)

OnLine Power
1-2
Danger!
ALL POWER CONNECTIONS MUST BE COMPLETED BY A LICENSED
ELECTRICIAN WHO IS EXPERIENCED IN WIRING THIS TYPE OF EQUIPMENT.
WIRING MUST BE INSTALLED IN ACCORDANCE WITH ALL APPLICABLE
NATIONAL AND LOCAL ELECTRICAL CODES. IMPROPER WIRING MAY
CAUSE DAMAGE TO THE EQUIPMENTS, INJURY OR DEATH OF PERSONNEL.
VERIFY THAT ALL HIGH AND LOW VOLTAGE INPUT POWER CIRCUITS ARE
DE-ENERGIZED AND LOCKED OUT BEFORE INSTALLING CABLES OR
MAKING ANY ELECTRICAL CONNECTIONS.
Danger!
EXERCISE EXTREME CARE WHEN HANDLING UPS AND BATTERY
CABINETS TO AVOID EQUIPMENT DAMAGE OR INJURY TO PERSONNEL.
CABINETS WEIGH SEVERAL HUNDRED POUNDS.
Danger!
TEST LIFT AND BALANCE THE CABINETS BEFORE MOVING. MAINTAIN
MINIMUM TILT FROM VERTICAL AT ALL TIMES. THE BOTTOM STRUCTURE
WILL SUPPORT THE UNIT ONLY IF THE FORKLIFT FORKS ARE
COMPLETELY UNDERNEATH THE UNIT.
Danger!
OBSERVE ALL BATTERY SAFETY PRECAUTIONS DURING INSTALLATION
OR SERVICE OF THE UPS OR BATTERIES. EVEN WITH THE BATTERY
CIRCUIT BREAKER IN THE OFF POSITION, THE DANGER OF
ELECTROCUTION MAY STILL BE PRESENT. THE BATTERY POWER TO THE
UNIT MUST BE LOCKED AND TAGGED “OFF” BEFORE PERFORMING ANY
SERVICE OR WORK ON THE UNIT. THE BATTERY MANUFACTURER’S
SAFETY INFORMATION AND MATERIAL SAFETY DATA SHEET IS LOCATED
IN A POCKET ATTACHED TO THE INSIDE OF LEFT DOOR OF EACH UPS.
FAILURE TO FOLLOW THOSE INSTRUCTIONS AND THE INSTRUCTION
LISTED ABOVE AND ELSEWHERE IN THIS MANUAL COULD RESULT IN AN
EXPLOSION, FIRE, EQUIPMENT FAILURE, OR ELECTROCUTION.