Olson Technology OT-1000-HH Rev.X4 - Manual (Page 3)

025-000573 Rev. X4 - 3 - www.olsontech.com
SAFETY
Safety Precautions
The optical emissions from the units are laser-based and may present eye hazards if improperly used. NEVER
USE ANY KIND OF OPTICAL INSTRUMENT TO VIEW THE OPTICAL OUTPUT OF THE UNIT. Be
careful when working with optical fibers. Fibers can cause painful injury if they penetrate the skin.
Laser Safety Procedure
ALWAYS read the product data sheet and the laser safety label before powering the product. Note the opera-
tion wavelength, optical output power and safety classifications.
If safety goggles or other eye protection are used, be certain that the protection is effective at the wavelength
emitted by the device under test BEFORE applying power.
ALWAYS connect a fiber to the output of the device BEFORE power is applied. Power should never be ap-
plied without an attached fiber. If the device has a connector output, a connector should be attached that is
connected to a fiber. This will ensure that all light is confined within the fiber waveguide, virtually eliminat-
ing all potential hazards.
NEVER look at the end of the fiber to see if light is coming out. NEVER! Most fiber optic laser wavelengths
(1310nm and 1550nm) are totally invisible to the unaided eye and will cause permanent damage. Always use
instruments, such as an optical power meter, to verify light output.
NEVER, NEVER, NEVER look into the end of a fiber on a powered device with ANY sort of magnifying
device. This includes microscopes, eye loupes and magnifying glasses. This WILL cause a permanent and ir-
reversible burn on your retina. Always double check that power is disconnected before using such devices. If
possible, completely disconnect the unit from any power source.
If you have questions about laser safety procedures, please call Olson Technology before powering your
product.
Attention:
Please read the instructions completely and carefully
before putting the unit into operation!
All operation steps should be carried out in the pre-
scribed sequence!
Improper putting into operation can cause serious dan-
ger for personnel and/or damage the device.
INVISIBLE LASER RADIATION
DO NOT STARE INTO BEAM OR VIEW DIRECTLY
WITH OPTICAL INSTRUMENTS
CLASS 1M LASER PRODUCT
MAXIMUM OUTPUT POWER: 150mW
WAVELENGTH: 1550nm
IEC 60825-1 (08/2001)