DirecTV ProScan DSS Receiver - Manual (Page 69)

Reference
67
Programming the Remote to Control
Other Devices
The AUX button is a device button that can be programmed to control a
second VCR, a cable box, or a laserdisc player.
1. Turn on the device to be programmed.
2. Look up your brand and its code number on code list on the
following pages.
3. Press and hold the AUX button.
4. Enter the three-digit code from the code list.
6. Release the AUX button and press POWER or CHAN UP/DOWN to
see if the device responds to the remote commands.
7. Repeat these steps using the next code listed for your brand until
the device responds to the remote commands.
Using the Remote Buttons to Control
a Device
Once the remote has been programmed with the correct codes, you are
ready to use it to control your devices.
To operate the device:
1. Press the device button (TV, DSS1, DSS2, VCR, or AUX) to set the
remote to control the device.
2. Press POWER to turn the device off or on.
3. Use the remote buttons that apply to that device.
After you program the remote to control
a device, record your AUX code here
for easy reference.
This remote may not operate all models
of the brands that are shown. Use the
codes shown in this manual, or on the
sheet packed with your remote.