DirecTV ProScan DSS Receiver - Manual (Page 20)

First Things First
18
Connecting a Compatible
D-VHS VCR
The DSS ® receiver can send a digital signal to a compatible D-VHS
VCR. The D-VHS VCR can then record and playback recordings
through the DSS
® receiver. If you have a D-VHS VCR you must
connect both devices so they can send and receive digital signals.
1) Connect a digital audio/video (DAV) cable as shown.
2) Connect RCA type audio/video cables as shown.
The D-VHS VCR and DSS ® receiver communicate through the DAV
cable. It is not necessary to connect the VCR controller or enter the
VCR type described earlier in this section.
Interactive Setup
If you self-installed your satellite dish antenna, you may have already
used the interactive setup to find the dish pointing coordinates, acquire
and fine-tune the signal, and run a system test.
If you need to run the interactive setup again, select Options from the
Main menu, then select Interactive Setup.
If you just want to check your dish pointing coordinates, or run the
signal strength meter, select Dish Pointing from the Main menu.
Ordering DSS ® Programming
After you have installed your system, you should contact the service
providers, DIRECTV and USSB to receive DSS
® programming.
Programming with DIRECTV: Call 1-800-347-3288
Programming with USSB: Call 1-800-204-USSB
When you order programming, you
need to know your Access Card number.
To get the number, select Options from
the Main menu, then
System Options,
and then select System Test.
Wait for the system to run all of it’s
tests. The Access Card number is
displayed at the end of the system test.
Write the Access Card number in the
space below for easy reference:
________________________________
VIDEO
DSS
RECEIVER
D-VHS
VCR
IN FROM ANT
OUT TO TV
S-VIDEO
L R
SATELLITE IN
AUDIO
L R
L R
VIDEO
AUDIO
AUDIO IN VIDEO IN
CH3
CH4
IN FROM ANT
OUT TO TV
D-VHS
D-VHS
AUDIO OUT VIDEO OUT