NavCom SF-2040 Rev.E - Manual (Page 25)

SF-2040 User Guide - Rev. E
To charge the batteries follow the procedure below:
y Connect the Universal AC/DC adapter
(
P/N 82-020003-5001) to the battery charger
assembly ( P/N 92-310046-3001).
y Plug the opposite end of the Universal AC/DC
power adapter into an AC receptacle. The GREEN
POWER LED should light up.
y Insert each battery into a battery bay. The RED
LED adjacent to that bay will light.
y One full charge cycle takes ~8 to ~10 hours to
complete.
Installing/Removing the Batteries
‡
The batteries are Lithium Ion type, which have none of
the memory effects seen in NiCad rechargeables.
Batteries are shipped in a partially charged state.
Batteries should receive one full charge cycle before
use.
a
The batteries should be removed from the SF-2040 if
the unit will not be used for >1 week, see Chapter 5
Safety Instructions/Battery.
0
Warning: Lithium Ion Battery Pack should be used
with designated charger only! Do Not short circuit
battery contacts. Do Not store above 60 deg C (140
deg F). Do Not disassemble battery. Do Not expose
to fire, explosive hazard. DO dispose of the battery
in accordance with the manufacturer’s
specifications. (See Chapter 5 Safety Instructions).
3-23