Direct ethernet connection via static ip address – NavCom SF-3050 Rev.A User Manual
Page 86
SF-3050 User Guide – Rev A
3-84
5. Click
the
Send button to start logging the
scheduled messages. Messages are logged in
.dat format to the USB flash drive.
If an error message appears, it may be
related to the compatibility of the USB flash
drive. Contact NavCom Customer Support:
The logging commands are: [LOGFILE]start,
[LOGFILE]pause, [LOGFILE]stop,
[LOGFILE]resume, and [LOGFILE] (returns
current logging status). After power cycle, the
file logging is in Stopped status.
To avoid file system corruption on the
USB flash drive, always stop file
logging before removing the drive.
Direct Ethernet Connection Via Static IP Address
There are many possible Ethernet configurations.
This section only provides the basic configuration for
a direct Ethernet connection between the SF-3050
and a PC.
Ethernet cables are not supplied with the SF-3050.
These Ethernet cables are available via a NavCom
authorized representative, or by contacting the
Positronic 9-Pin Male to Ethernet RJ45 Plug
(P/N 94-310265-3006LF). This cable is used in
the setup below.
Y-Cable, Positronic 9-Pin Male to Ethernet RJ45
Plug & DB9S (RS-232/1PPS) (P/N 94-310272-
3006LF)