Factory default output messages, Table 23: factory default nct messages, Responses – NavCom SF-3050 Rev.A User Manual
Page 109
SF-3050 User Guide – Rev A
5-107
The user has full control over the utilized message
types and their associated rates via either
StarUtil-3000 or a third party software/utility.
Factory Default Output Messages
NCT
Messages
Table 23: Factory Default NCT Messages & Response
Output on Ports COM1 and USB1
s
Message Rate Description
ALM1B On
Change
Almanac
CHNLSTA
nnel
TUS1B
On Time 1Hz
ASIC & StarFire Cha
Status
EPHEM1B
On Change
Ephemeris
MEAS1B
(see
ata
Note
t D
below)
On Time 1Hz
Raw Measuremen
MSG
Serial
PRODUCTINFO
On Time 600 Sec
Product Type, Digital
Number, and System
Revision Number
MSGVERSION
On Time 600 Sec Identification Block
PVT1B
On Time 1Hz
PVT Solution
PANICA
On Change
Factory Use
Output on All Ports
Mes
ription
sage Rate Desc
OK (mnem
d”).
ssful
onic)
On Change
Ack (“Acknowledge
Ack indicates a succe
operation.
?? (mnem
ged”).
e in
d.
onic)
On Change
Nak (“Not Acknowled
NAK indicates a failur
executing a comman
PANICA
On Change
Factory Use