NavCom SF-3050 Rev.A - Manual (Page 34)

SF-3050 User Guide – Rev A
1-32
38. Do not close StarUtil-3000. Perform one of these
steps:
• If a StarFire License is purchased, go to the
Upload StarFire License section.
• If a StarFire License is not purchased, go to
the Factory Default User Profile section.
Upload StarFire License

For this initial configuration, the
StarFire license must be installed via
data cable. Subsequent renewals of
the license are typically transmitted to
the receiver via radio broadcast. Refer
to Chapter 5/Over The Air StarFire
Licensing for details.
The receiver must be Tracking GPS
satellites and providing a valid position
solution at the time of the StarFire
license upload to accept the license.
39. Select StarFire License in the File Upload window
(see Figure 19).
Figure 19: StarFire License
40. Click the button.
41. Browse to NavCom\StarFire License on the PC.
The StarFire License file extension is *.dat.
42. Select the StarFire License file. The path to the
file appears in the upload field (see Figure 20).