beautypg.com

Upload firmware, Figure 11: receiver options – NavCom SF-3050 Rev.A User Manual

Page 29

background image

SF-3050 User Guide – Rev A

1-27

23. Perform one of these steps:

• If the NAV firmware installed in the receiver is

the most current version, go to the Upload
Software Options
section below.

• If the NAV firmware installed in the receiver is

not the most current version:

• Check the versions of the other firmware.
• Write down all the firmware that must be

updated.

• Go to the Upload Firmware section below.

Upload Firmware

The required PC Baud rate to upload
firmware via the supplied DB9S cable
(RS-232) on COM2 is 57600 (default). This
requirement does not apply to the supplied
USB 2.0 Device cable.

Typically, if any firmware needs to be
updated, it is NAV and PIOAPP.

24. Click Receiver Options in

the Detailed Views menu
on the left side of the GUI
(see Figure 11). The
Receiver Options tab
opens.

Figure 11: Receiver Options