Montigo HFK50 - Manual (Page 4)

Installation
Page 4
XT0014 - 092214
10. Secure the Fireplace powercord to the fireplace floor using cable
ties, away from the door buckle and other moving parts.
Figure 12
12. Slide in the Heat Sensor to the existing bracket attached to the bot-
tom of the burner tray. If fireplace bracket is not available, use the
bracket supplied with the heat sensor switch and use self-tapping
screws to mount them to firebox bottom.
Figure 13
11. Reinstall the burner tray. See Figure 2 or Figure 3 for examples
13. Complete the installation as per the fireplace installation manual
and start-up the fireplace. Turn the fans on using the DRB001
control box.
Note: It may take up to 15-20 minutes for the fans to turn on, as your
fireplace will need to reach a temperature of 130 F (at the heat
sensor) before the fans will start.
14. Use the speed control knob to adjust the fan speed to the desired
setting.
The fans only operate when the unit is running. You may
turn the fans off completely using the DRB001 knob.