Montigo R324-ST - Manual (Page 12)

R324-STIO Indoor Outdoor Ventless Gas Fireplace
Page 12 XG0775 - 150204.1
Installation
Section 6-a: Removing & Installing the Interior Screen and Door
Step2. Remove the supplied glass lifting tool from the packaging. Place in the
center of the Glass door as shown, and activate the suction feature of the tool, Figure
7a. NOTE: Read ALL the instruction supplied with the tool, and follow the associated
operating procedures.
Figure 7a. Supplied Glass lifting tools.
Figure 7b. (Lift the door upward) Figure 7c. (Lift the bottom of the
door outward).
Figure 7d.
Step3. Hold the Glass Removal Tools firmly, Lift the door upward, into the top door
frame, Figure 7b. Then pull the bottom of the glass door downward, and tilt outward
from the bottom fireplace door frame. Figure 7c. NOTE: Read ALL the instructions
supplied with the tool, and follow the associated operating procedures.
Step4. Still holding the Glass Removal Tool
firmly, remove the door outward, and away
from the Fireplace, Figure 7d.
Step5. Place the door in a safe location while
maintenance, cleaning or other operation are
in progress.
NOTE: Read ALL the instructions
supplied with the tool, and follow the
associatedoperatingprocedures.
Step6. To reinstall, reverse steps.
Lift Upward into
the door frame.
Lift Downward
& away from frame.
Do not use ammonia based or abrasive cleaners on the glass, they will permanently
etch the surface. Use an approved gas fireplace glass cleaner such as Kel-Kem or
White off.
NOTICE
Removing the Screen and Door:
Step1. Remove the screen by pulling firmly with your fingers, and remove from
the bottom then the top. (See Figure 7).
Figure 7. Removing the screen