Montigo P52DF - Manual (Page 23)

Page 23
P52DF* Indoor Gas Fireplace
XG0196 - 150204.3
Installation
To install the door, hook the top edge of the door frame into
place. Lower the door into position and follow the previous
steps shown in reverse order.
Installing the Door:
Step 8:
Grasp the Door on either side, usually midway and
lift upward, lift the door carefully up and away from
the front of the fireplace. See Figures 22g. Place the
Door aside in a safe place while maintenance and / or
cleaning is being performed.
Figure 22g. Removing and installing the glass doors.
Removing the Door:
Section 9: Installing the Accessories
Installing the Firestones or optional Fireglass
The P52DF* is supplied with firestones. Optional
fireglass may be purchased from the factory. Remove
the Door as shown in the previous Instruction. Follow
these instructions to ensure all parts are removed or
replaced as required. Once the glass door is removed
place the firestones randomly across the pan and the
burners as described in Figure 23 to 23f.
Note: Only cover the burner with one layer of designer
firestones or fireglass.
Figure 23b. Installation of the firestones. (Ensure ONLY
one layer of firestones cover the surface).
Figure 23c. Spreading the firestones evenly and make sure
there are no firestones covering the pilot .
Figure 23. Up-lighting glass in package.
Figure 23a. Place the up-lighting glass in the burner tray.
WARNING
When installing the fireplace - gas lines, fittings,
accessories or any other objects cannot impede the
proper movement of the door buckles.