MK Products Advanced Color Logic Rev.C - Manual (Page 40)

Advanced Color Logic Owner’s Manual - Page 35
Simply follow the procedure below:
Copy the existing procedures to the drive and directory containing the ACL
program.
At the MAIN MENU, use option [F Copy Procedure From Disk] to recall the
saved procedures. Press [ENTER] to select highlighted procedure.
At the prompt “——— Procedure OK to Discard?” answer [Y]. This will return
you to the MAIN MENU.
7.12 Using Procedures From ATW Software
Versions Prior To 3.0
In order for the system to recognize information developed and saved on
versions prior to revision 3.0, you must save them on a version later than 3.0.
You need not re-develop each procedure, as long as you want all aspects of
the procedure maintained.
To save procedures from an old version to a new version, simply copy the
procedures from the old version diskette onto the new version diskette. Install
the diskette into the ATW welder and modify and rename as needed and
re-save onto the diskette. This process will save procedure using “new” format.
Refer to the prior section on copying procedures for using these procedures
on the ACL.
Section B
(Cont.)