Metz MECABLITZ 52 AF-1 digital Pentax - Manual (Page 160)

160
9.3.4 Setting partial light output level or
exposure correction
• Press the sensor button on the touch dis-
play for the partial light output level /expo-
sure correction (e.g
or ) .
The window for the selection appears.
• Press the sensor buttons on the
touch display and set the desired partial
light output level (e.g.
)or exposure
correction (e.g ) .
• Press the sensor button for the desired par-
tial light output level or exposure cor-
rection (e.g )
The setting is applied immediately.
1/16
1/1
1/1
EV
EV
EV
9.4 Testing remote flash mode
• Place the slave flash units in the desired
positions for the shot. Use flash unit moun-
ting foot S60 to set up the slave flash unit.
• Wait for all of the flash units involved to
become flash ready. Once the slave flash
units are flash ready, the AF measuring
beam
ቯ will blink.
• Press the manual firing button on the
master flash unit to fire a test flash.
The slave flash units will respond in succes-
sion, according to slave group, with a test
flash. If a slave unit fails to fire a test flash,
check the settings for remote channel and
slave group. Correct the position of the sla-
ve flash unit so that it is able to receive
light from the master flash unit via the sen-
sor
ብ.
The flash mode is transmitted automatically
by master.
When the flash unit functions as master in
the cordless remote system, the activation of
the modelling light also activates the model-
ling light of slave flash units.
REMOTE
SLAVE
INFO 1/1
Z OOM 35 mm
M
CH
1
REMOTE
SLAVE
INFO 1/16
Z OOM 35 mm
M
CH
1
1/1
1/1 -1 /
3
1/8 -2 /
3
1/16
1/16 -1 /
3
k